• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

Peugeot 308 Key Fob Replacement

Peugeot's 308 is a little old, but it is still attractive. It's not the most luxurious car in its class, but it is a pleasant and peaceful driving experience.

We often receive requests from Coded Car Keys to replace Peugeot 206 key fob and reprogramming key fobs. The following tips can help whether the problem is persistent or intermittent.

Water Damage

If you accidentally drop your key fob in an eddy, or it is soaked while kayaking, canoeing or rafting or canyoning the fob is more likely to be damaged by water. The best way to prevent this from happening is to keep it in a dry bag when you're going outdoors or doing activities where the fob could be exposed to a lot of water.

You'll also want to ensure that the fob is completely dry before opening it up and reusing it. If you detect any smells emanating from the fob such as an industrial-type smell or a sour taste like windshield washer fluid, it's another sign that it's submerged in water.

A circuit board that's wet can cause the battery's charge to drop its charge, or even explode. If you are able to get your keyfob 308 from the water you need to turn the button side up and shake as much water as you can prior to opening the casing. Take the battery out, and then clean the circuit board with a cotton swab, which has been submerged in 90 percent alcohol.

Other reasons your Peugeot 308 remote entry keyless system may not work include a dead battery in the coin-cell or receiver module issue, signal interference or a malfunctioning chip. If none of the above is the issue you can reset the system by disconnecting the 12 Volt battery from the car for 15 minutes.

Dead Coin Battery

Peugeot cars come with a remote start system which allows drivers to start their car from an extended distance, which allows them to warm up or cool down the vehicle before they get in. This feature is very beneficial, especially in the cold winter months. The remote start system may be stopped for a variety of reasons, such as a dead coin-battery.

A coin-shaped battery that is in the key fob has a life span of between two and four years, depending on how often it is used and the location where it was purchased. The date of use is usually found on the packaging or listed in the instruction manual.

If the key fob has stopped working after being exposed to pure tapwater, you need to remove the battery and clean the electronic chip using the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip completely before replacing. If the key fob has been exposed to salty or soapy water, it may have fried the chip. You will need to replace it.

If you are not sure the battery is defective, you can test its voltage with an instrument set to the car's voltage range, and connect it to the terminals for minus and plus. The voltage should be between 12-13 volts but if it's lower, the battery must be replaced. If you want to, you can attempt to reset the onboard computer by disconnecting the 12 volt battery for a couple of minutes, and then reconnecting it in reverse order (positive cable first and then negative). The engine should start.

Faulty Receiver Module

If you're not receiving the "Key Detected" message on your dashboard, it's possible the receiver module has developed a fault. It's the component that sends an alert to the car when your key fob is activated, which also acts as an immobiliser. It also stops it from starting until the correct key is in place.

The cause could be several factors, including water damage or just the aging process. If the electronic chip within your peugeot spare key 308 keyfob is damaged by dirty tap water it could be because the keyfob was in contact with it. In this scenario you'll need to remove off the battery and thoroughly clean it with isopropyl alcohol, or electronic cleaner. When the battery is dry you can try it again.

If the issue is not resolved, it is recommended to consult the local Peugeot expert or locksmith. They can employ a diagnostic tool in order to identify the issue and then fix it.

It can be stressful to lose your Peugeot car key. However, a qualified auto locksmith can resolve the problem in minutes. They can cut a brand new key and programme it to your vehicle, ensuring you're back to the road in the shortest amount of time. Click here to find a locksmith near you.

Electronic chip malfunctions

The chip inside your Peugeot 308 key fob is an important part of the remote control system. If it gets damaged, your car may not start or receive a message saying "anti-theft active". If this happens, the only way to fix the issue is to purchase a new key. Luckily, professional auto locksmiths are able to provide this service within the shortest period of time.

The chip inside your Peugeot 308 key fob can become faulty due to water damage, sweat dirt, or any other cause. If your Peugeot key fob has been exposed dirty or soapy water, it needs to be cleaned right away. You can clean the electronic component with a paper towel soaked in isopropyl Alcohol. The battery should be allowed to fully dry.

Sometimes the key fob may stop working because of radio interference. This can be caused when other devices use the same frequency as your peugeot partner key keyfob. This could be due to bad conditions or objects in the vicinity of the vehicle. If you experience this problem, it is best to visit an Peugeot dealership.

The peugeot 207 new key Key Fob 207/308 is fragile and requires particular care. It is crucial not to throw or drop the key fob. If you lose it, try to find it as quickly as you can. You can reset the on-board computer by disconnection of the battery for a couple of minutes. Disconnect the negative cable prior to the positive.